Since 2014 · Coimbatore, India
Industrial lighting and pump controls, built to spec.
LED luminaires up to 160 lm/W and automatic pump controllers, designed, built and photometry-tested in our own factory for contractors, OEMs and dealers.
Since 2014
Making lights in Coimbatore
30,000
Luminaires a month
160 lm/W
Peak efficacy, Prime 135W
ISO 9001:2015
Certified by TÜV NORD
UL tested
Street light test reports
In-house lab
Integrating-sphere photometry
What we make
Two product lines from one factory
Lighting for industrial, outdoor and everyday spaces, and controls that run domestic and farm pumps automatically. Both are designed, built and tested by the same team in Coimbatore.
Lighting
LED luminaires from 9W to 240W
Die-cast bay, flood and street lights up to 160 lm/W, plus aluminium and IP65 battens.
Pump controls
Automatic pump controllers and float switch
Start on pressure drop, stop when flow stops, cut out on dry run. Rated to 10 bar.
Tested before it ships
The sphere test
Every Futr luminaire design is measured in our own integrating sphere before it goes into production. Pick any model and watch it go through the test, with its catalogue readings.
Prime 135W · measured
- Luminous flux
- 21,600lm
- Efficacy
- 160lm/W
- Colour temperature
- 5,700K
- Surge protection
- 6kV10 / 20 kV optional
Matches the catalogue. IP66, IK07, 5 year warranty.
How we work
From our lab to your site
Designed
Every luminaire starts at our drawing board: housing, optics and heat path designed around the job, with our own fixtures for most models.
- Die-cast aluminium housing
- Lens optics
- Own fixtures and tooling
Tested in our lab
Before release, each design goes into our integrating sphere for lumens and efficacy, and through electrical and surge testing.
- 21,600 lm measured
- 160 lm/W
- 6 kV surge protection
Installed on your site
Shipped to contractors and dealers across India and hung in warehouses, plants and yards, rated for up to 1,00,000 hours.
- IP66 · IK07
- Up to 1,00,000 h L70
- 5-year warranty
Applications
Where our products work every day
How ACV and ACH controllers work
Automatic pump control, explained
The controller sits between pump and pipe. Open a tap and pressure falls, so the pump starts. Close it and flow stops, so the pump stops. If the source runs dry, it cuts the motor out. Try it below.
Adjustable from 1.3 to 2.3 bar. The pump starts when pressure falls below this.
A simplified model of the ACV and ACH: start on pressure drop, stop when flow stops, cut out on dry run. The pressure the pump builds depends on your pump and pipework.
For dealers
Sell lighting and pump controls from one supplier
Two product lines your electrical and plumbing customers buy together, backed by factory capacity and five-year warranties on our core luminaires.
Catalogues